Skip to content
Orbit 8K
Low throttling riskNew Zealand

Stop IPTV Buffering on Orcon

Orcon customers in New Zealand often see unexplained buffering in the evening or a block page on streaming hosts. The cause is traffic shaping or DNS filtering, and the fix takes about five minutes.

Typical symptoms on Orcon

  • Older supplied routers struggling with 4K Wi-Fi
  • Default resolver slowness
  • Evening congestion on Hyperfibre upgrades during switch-over

Recommended DNS servers

Replace the default Orcon resolver on your router or streaming device:

Primary DNS: 1.1.1.1
Secondary DNS: 1.0.0.1

Recommended streaming port

Our servers answer on an encrypted TLS port that deep packet inspection cannot classify as video:

Use port 8080 (https server address from your welcome message)

Fix Orcon buffering in 3 steps

  1. 1

    Change DNS on the router

    Log in to the Orcon router and set DNS to 1.1.1.1 / 1.0.0.1 under LAN or DHCP.

  2. 2

    Use the 8443 address

    Edit the playlist in your player and use the https server URL on port 8443.

  3. 3

    Wire the main TV and raise the buffer

    Connect the Fire TV, Apple TV or Smart TV by Ethernet (or a USB-C Ethernet adapter) and set the player buffer to 2–3 seconds. Most remaining stutter is Wi-Fi, not the ISP.

Orcon questions

Does Orcon block IPTV?

Orcon does not block IPTV as such, but its security filters and evening traffic shaping can slow unencrypted video. The three steps on this page remove both.

Do I need a VPN?

No. The encrypted 8443 route and a DNS change do the job without adding VPN latency.

Which DNS should I use on Orcon?

1.1.1.1 as primary and 1.0.0.1 as secondary, set on the streaming device itself where the router locks DNS.

Test a buffer-free stream on Orcon

Request the free 24-hour trial and see OrbitLock Anti-Freeze 9.2 hold a 4K match through the evening peak.